Disp.mode. Setting - JRC NJJ-105 Handy Search User Manual

2.3.20 disp.mode. setting

You can specify the initial setting for disp. mode (the display mode) at the power on by this
parameter. The available settings are the last end and default . The the last end sets the
previous setting at the power off to the display mode at the power on. The default sets the
pre-defined display mode ( B ) to the display mode at the power on. Set a desired setting to this
parameter in accordance with the procedure described in section 2.3.
2.3.21 Amplitude. setting
You can specify the initial setting for amplitude (the amplitude specifying zero axis of the A-mode
waveform and the color gradation of the B-mode display) at the power on by this parameter. The
available settings are the last end and default . The the last end sets the previous setting at the
power off to the amplitude at the power on. The default sets the pre-defined setting ( abs ) to the
amplitude at the power on. Set a desired setting to this parameter in accordance with the procedure
described in section 2.3.
2.3.22 X-axis. setting
You can specify the initial setting for X-axis (the X-axis specifying a scan mode) at the power on
by this parameter. The available settings are the last end and default . The the last end sets
the previous setting at the power off to the X-axis at the power on. The default sets the pre-defined
setting ( distance ) to the X-axis at the power on. Set a desired setting to this parameter in
accordance with the procedure described in section 2.3.
2.3.23 depth. setting
You can specify the initial value for depth (the depth specifying a depth calibration value) at the
power on by this parameter. The available settings are the last end and default . The the last
end sets the previous value at the power off to the depth at the power on. The default sets the
pre-defined value ( 8 ) to the depth at the power on. Set a desired setting to this parameter in
accordance with the procedure described in section 2.3.
- 24 -