Dist. Adj; Output - JRC NJJ-105 Handy Search User Manual

2.3.10 dist. adj.

You can specify the distance correction constant by this parameter. This product determines its
scanning distance using the number of rotations of the wheel. Thus, wear of the wheels causes error
in determining the scanning distance. To remove erro in the scanning distance, this product
compensates the detected distance by using the distance correction constant set to this parameter.
If the scanning distance has error, enter the correct distance correction constant to this parameter by
performing the following procedure.
Example of the scanning distance compensation:
a) Perform a 1m (actual value) scan and stop the scan.
b) Press the 4 SET key to show the parameter setting screen
c) Select the dist.. adj by using the ▲▼ cursor keys and enter the setting field by using the
cursor keys.
d) Adjust the distance correction constant by using the ▲▼ cursor keys so as the distance value
displayed by [ ] to the right of the distance correction constant is as close as possible to 1 m.
e) Exit from the setting field by using the
return to the scan screen.
Remarks
• The scanning distance of the last scanning is displayed at the right of the distance
correction constant. When the distance correction constant is changed, the scanning
distance is also changed. Adjust the distance correction constant by refering this
scanning distance value.
• The new distance correction constant becomes effective from the next scan. The
new distance constant is not reflected to the existing test results.
• When setting a value ≧ 13 to the distance correction constant , scanning the
distance longer than 10m, and printing the scan result at the wide display range
setting ( DW :Deep Wide,
result may show a part which is difficult to read.

2.3.11 output

You can specify the destination and format of the external data output by this parameter. The
available settings are printer(I) , CF[text] , and CF[binary] . Also a character showing the current
setting is displayed at the lower right of the scan screen. The table below shows the relationship
among the setting, destination and format, and character displayed at the lower right of the scan
screen . See Section 3.6 External output methods for the operation method. Set a desired setting to
this parameter in accordance with the procedure described in section 2.3.
Setting
Printer (I )
CF [text]
CF [binary]
NW :Normal Wide,
External data output
Print to the printer
Saved in text format in CF memory
Saved in binary format in CF memory
- 21 -
cursor keys and press the 4 SET key to
SW :Shallow Wide), the printed
Character displayed
on the scan screen