Parameter Setting Screen; Disp. Color; Disp. Direction - JRC NJJ-105 Handy Search User Manual

2.3 Parameter setting screen

The parameter setting screen Is used to see the current setting and to change the setting for each
parameter. To access this screen, press the 4 SET key while the scan is stopped, then the parameter
setting screen shown in Figure 2-6 appears. To change the setting of a parameter, move the cursor
(inverse video line) on the parameter by pressing the ▲▼ cursor keys, press the
enter into the setting field of the parameter. Select a desired setting by pressing the ▲▼ cursor keys, then
press the cursor keys to exit from the setting field. To exit from the parameter setting screen, press
the 4 SET key again.
Regarding the operation to read out the scan data in CF memory, see Section 3.7.2 Reading saved
data.
Parameter

2.3.1 disp. color

You can specify the display color used in the B-mode display by this parameter. The available
settings are Color1 , Color2 , Color3 , Monochrome1 , or Monochrome2 . Set a desired
setting to this parameter in accordance with the method described in section 2.3. When changing
the setting, the color bar displayed at the amplitude setting field automatically changes and
shows visually the selected display color.

2.3.2 disp. direction

You can specify the display direction by this parameter. The available settings are normal and
invert . When setting invert to this paramter, the screen display is inverted on the scan screen
Setting
Figure 2-6 Parameter setting screen
- 16 -
Parameter
cursor keys to
Setting