Amplitude - JRC NJJ-105 Handy Search User Manual

2.3.4 amplitude

You can specify the zero axis of the A-mode waveform and the color gradation used in the
B-mode display by this parameter. The available settings are abs and offset .
The abs sets the zero axis of the A-mode waveform (absolute amplitude) at the
vertical center line in the A-mode diaply, and the offset sets the zero axis of the A-mode
waveform (offset amplitude) at the left edge of the A-mode display.
When the display color is set to Color1 , Color2 , or Color3 , the abs uses the color
gradation in the B-mode display which changes the drawing color between Black → Indigo → Green
→ Yellow → Red as the absolute amplitude of the A-mode waveform increases as shown in Figure
2-8 Abosolute value. The offset uses the color gradation changing the drawing color between
Black → Indigo → Green → Yellow → Red as the offset amplitude of the A-mode waveform
increases as shown in Figure 2-8 Offset.
When the display color is set to
the color gradation in the B-mode display which changes the drawing color between White
→ Gray → Black as the absolute amlitude of A-mode waveform increases. The
uses the color gradation changing the drawing color between White → Gray → Black as
the offset amlitude of the A-mode waveform increases.
Set a desired setting to this parameter in accordance with the procedure described in section 2.3.
Monochrome1
Absolute value
Figure 2-8 Gradation
or Monochrome2 , the abs uses
- 18 -
Offset
offset