Replacing Belt 3, Cutting Unit Drive - Husqvarna Rider 100 series Workshop Manual

Repair instructions
7 Pull belt 3 off the unit belt pulley.
8 Lift off belt 4 over the unit belt pulley and
forwards.
Fit the belt in the reverse order.
44 – English

Replacing belt 3, cutting unit drive

Follow the instructions for "Replacing belt 4, as far
as the cutting unit" up until step 7. Then proceed
according to the following instructions:
1 Remove the rear cover of the front frame.
2 Remove the spring for the belt tensioner for
belt 1 (engine belt).
3 Remove the belt tensioner for belt 1.