5
13 Loosen the two screws (4) using a half-inch
wrench. Loosen the screw (5) behind the muffler
and the screw (6) holding the exhaust pipe. The
belt guide can now be removed.
IMPORTANT INFORMATION
When assembling, the gasket between the
muffler and the exhaust pipe must be replaced.
Rider 111 B5
4
4
6
14 Jack up the front carriage in front of the cable
pulley without squeezing any cables. Jack up
the rear carriage in the rear edge.
15 Use a slide hammer size M8 to loosen the
articulated shaft and the belt pulleys.
16 Separate the front and rear carriages.
Repair instructions
English – 35