Husqvarna Rider 100 series Workshop Manual page 23

5 Place a suitable vessel underneath the fuel tank
to collect the gasoline in.
6 Remove the clamp and hose from the fuel tank
and drain the fuel into the vessel. There are two
fuel hoses on Rider 120C and 120S.
7 Unscrew the two screws and washers holding
the fuel tank.
Save the washers for refitting the fuel tank!
8 Disconnect the engine pin connector, the ground
cable and the starter motor cable.
x2
9 Disconnect the throttle cable.
10 Unscrew the heat shield for the muffler.
x2
English – 23