Slant/Fin Jaguar J-390 Installation And Operating Instructions Manual page 31

Jaguar Model J-390
"RESET" PUSH BUTTON
"BURNER STATUS"
STEADY DOT = BURNER ON
BLINKING DOT = BURNER OFF
Figure 22. Display Board
Table 1
Table 2
Table 1
Table 2
Table 1
Table 2
Table 1
Table 2
Table 1
Table 2
MODE
Table 1
Table 2
DISPLAY
Table 2
NOTE:
Blinking dot on "Mode Display" indicates active heating control, burner off.
Steady dot indicates burner is on.
*: Error must be corrected to resume boiler operation. Pressing the "Reset" button is not required.
**: The boiler loop circulator is energized, if the boiler water temperature drops below 50˚F.
***: Error must be corrected to resume DHW operation. Space heating not affected. Pressing
the "Reset" button is not required.
"MODE" DISPLAY
JAGUAR BOILER DISPLAY BOARD
"Boiler Operation Status"
Table 3
Table 3
Table 3
Table 3
Table 3
Table 3
Table 1
Table 3
Reset button must be pressed to resume normal operation.
"TEMPERATURE" DISPLAY (3 DIGITS)
"UP" PUSH BUTTON
"DOWN" PUSH BUTTON
"ENTER" PUSH BUTTON
"SELECT" PUSH BUTTON
Table 3
DESCRIPTION & TEMPERATURE DISPLAY
Boiler is on stand-by mode.
Temperature display shows supply water Temp.
Space heating mode.
Temperature display shows supply water Temp.
Domestic hot water mode.
Temperature display shows supply water Temp.
Frost protection mode. **
Temperature display shows supply water Temp.
Lockout (Alarm) condition.
Temperature Display indicates the lockout code
Error Condition. *
Temperature display indicates the error code.
Warning Condition. ***
Temperature display indicates the error code.
31