Ip Rip Authentication Mode; Ip Rip Interface - Zte ZXR10 8900 Series Command Reference Manual

All manuals and user guides at all-guides.com

ip rip authentication mode

Related
Commands

ip rip authentication mode

Use this command to specify the authentication type for the RIP
Purpose
version 2 message packets. Clear the authentication with the no
form of this command.
Interface configuration
Command Modes
ip rip authentication mode {text | md5}
Syntax
no ip rip authentication mode
Syntax
Description
text
md5
There is no authentication mode by default.
Defaults
The RIP version 1 does not support the authentication.
Instructions
This example describes how to configure the MD5 authentication
Example
on the fei_1/1 interface.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ip rip authentication mode md5
ip rip authentication key
Related
Commands
ip rip authentication key_chain

ip rip interface

Use this command to configure the method to send/receive route
Purpose
information on an interface. Restore default with the no form of
this command.
Interface configuration
Command Modes
ip rip interface {passive | active}
Syntax
no ip rip interface
Syntax
Description
passive
active
The RIP route information is sent and received at the same time.
Defaults
�
Instructions
Simple text authentication
MD5 authentication
Enables an interface only to receive but not
to send RIP route update information.
Enables an interface only to send but not to
receive RIP route update information.
This command can be used to reduce the bandwidth occupation
of the network.
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 RIP Protocol
15