RIDGID R4512 Operator's Manual page 21

ASSEMBLY
INSTALLING THE HEIGHT ADJUSTING
HANDWHEEL
See Figure 20.
NOTE: The height adjusting handwheel knob and the bevel
adjusting handwheel knob act as locks. To lock the wheel
for operation, turn the knob clockwise until it is securely
tightened.
 Slide the handwheel over the bolt above the bevel
adjustment scale on the front of the saw.
 Slide the washer over the bolt.
 Screw the knob securely onto the bolt.
INSTALLING THE BEVEL ADJUSTING
HANDWHEEL
See Figure 21.
 Slide the bevel adjusting handwheel over the bolt on the
side of the saw.
 Slide the washer over the bolt.
 Screw the knob securely onto the bolt.
ACCESSORY STORAGE
See Figure 22.
Storage for the blade, blade wrench and miter gauge is
located on the side of the saw. The miter gauge may be
stored by sliding it into the slots.
The push stick contains a magnet. When not in use, the push
stick may be stored at a convenient location on the saw.
BOLT
BOLT
BLADE AND
HEIGHT
ADJUSTING
HANDWHEEL
WASHER
KNOB
Fig. 20
21 - English
WRENCH
STORAGE
KNOB
WASHER
BEVEL
ADJUSTING
HANDWHEEL
Fig. 21
KNOB
MITER GAUGE
STORAGE
Fig. 22