Making Check And Adjustment Of The Tilt - Canon Staple Finisher-AA1 Service Manual

3.
Turn the adjustment dial of the caster in the direction
of the arrow by lifting the dial upward a little to adjust
the height.
(A full turn of the adjustment dial changes the height of
the Finisher by 2.0 mm.)
• To increase the height of the Finisher, turn the dial
in the direction of arrow [A].
• To decrease the height of the Finisher, turn the dial
in the direction of arrow [B].
NOTE:
Adjust the height at four casters.
NOTE:
If the adjustment dial keeps lifting upward, lower the
adjustment dial by releasing three claws. And be sure to
insert the three pins of the adjustment dial to the hole of
the caster support plate.
Claw
Claw
Claw
Making Check and Adjustment
of the Tilt
1.
Check the relational tilting amount of the Finisher
and Host Machine. Make sure that the gap between
the right side of the Finisher and the left side of the
Host Machine is within the standard shown in the
figure. In the case the gaps are within the
specification, this adjustment is not required.
5.0-/+1.5mm
5.0-/+1.5mm
17.5-/+1.5mm
21.5-/+1.5mm
210
7. Installation