1. Perform rear stapling as test print of 5 sheets in a bunch, check that the paper is fed by the return roller during
output.
• In the case the paper is fed by return roller
Perform step 2
• In the case the paper is NOT fed by return roller(The return roller does not contact the paper)
Adjust the swing unit height by the following service mode. Input plus value and check again.
SORTER > ADJUST > SW-UP-RL
Adjustment range: -30 to 30 (Unit: 0.1 degree)
As the value is incremented by 1, the height of the swing unit is changed by angle of 0.1 degree.
+: Downward
-: Upward
Swing Unit
-
+
156
Paper
Return Roller
Feed Direction
-
+
5. Adjustment