Calibrating The Scanner - Plustek MobileOffice D430 User Manual

Calibrating the Scanner

Calibrate the scanner if colors appear in areas that should be white, or colors of
the scanned image and the original vary a lot. This allows you to adjust and
compensate for variations that can occur in the optical component over time by its
nature.
The following describes how to calibrate the scanner:
1. Please push up the cover of the Guide Paper Return. Insert the special
calibration sheet face up into the page feed slot of the scanner.
Attention
2. Click Start > All Programs > Your scanner model name > Calibration
Wizard. (For Windows 8.1 users: Point your mouse cursor to the upper or
lower right corner of your screen to open the Charm bar. Click on the Start
charm, then click on the downwards arrow button in the lower left corner of the
screen. The Apps screen will be shown. Move your cursor to the right edge of
the screen to scroll right until you find Your scanner model name, and then
click on Calibration Wizard.)
3. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now....
4. Click on the Start button to begin the calibration process.
5. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then
click Finish.
Please insert the special calibration sheet
included with the scanner. Alternatively you may
also use any plain white sheet of paper sized in
Letter/A4 instead; however, the calibration effect
may be less good than the special calibration
sheet.
21