Table of Contents
Advertisement
5. Install the paper chute by aligning and inserting the tabs of the paper chute into
their slots on the scanner.
6. Close the ADF cover by pushing it back down until it snaps back into place.
C
ALIBRATING THE
Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate
for variations that can occur in the optical component over time by its nature.
The following describes how to calibrate the scanner:
1. The Calibration Sheet, marked with an arrow on either edge at both sides, is
used specially for ADF Scanning calibration.
S
CANNER
44
Advertisement
Table of Contents
