Table of Contents
Advertisement
C
ALIBRATING THE
Calibrate the scanner if colors appear in areas that should be white, or colors of the
scanned image and the original vary a lot. This allows you to adjust and compensate for
variations that can occur in the optical component over time by its nature.
The following describes how to calibrate the scanner:
1. The Calibration Sheet, marked with an arrow on either edge at both sides, is used
specially for ADF Scanning calibration.
2. Insert the special calibration sheet into the ADF of the scanner, with an arrow
toward the scanner buttons.
Attention
3. Click Start > All Programs > Your scanner model name > Calibration Wizard.
(For Windows 8.1 users: Point your mouse cursor to the upper or lower right
corner of your screen to open the Charm bar. Click on the Start charm, then click
on the downwards arrow button in the lower left corner of the screen. The Apps
screen will be shown. Move your cursor to the right edge of the screen to scroll
right until you find Your scanner model name, and then click on Calibration
Wizard.)
4. Click Next from the Calibration Wizard that pops up and then click Calibrate
Now....
5. Click on the Start button to begin the calibration process.
6. The scanner pulls the calibration sheet through the scanner, which completes
this scanner calibration. After the calibration is complete, click OK and then click
Finish.
S
CANNER
Please insert the special calibration sheet included
with the scanner. Alternatively you may also use
any plain white sheet of paper sized in Letter/A4
instead; however, the calibration effect may be less
good than the special calibration sheet.
24
Advertisement
Table of Contents
