Furuno MU-201C Operator's Manual page 15

Main mark Sub mark
Position,
Phase
OSD
position
*: When inputting DVI, these marks are not shown.
Item
Auto adjustment*
Pixel adjustment*
Phase adjustment*
Horizontal position
adjustment*
Vertical position
adjustment*
Setting of OSD
time out
OSD location
8
Function
Adjusts image timing automatically.
Adjusts the number of pixels in the horizontal
direction. If there is pixel count mismatch
between analog signal and monitor, vertical
flicker and unclear text will result.
After selecting the item, adjust the image on the
bar.
To the left (◄) ↔ To the right (►)
Adjusts the timing of sampling so that the flicker
disappears and the text is clear.
After selecting the item, adjust the phase on the
bar.
To the left (◄) ↔ To the right (►)
Adjusts the image position horizontally.
After selecting the item, adjust the horizontal
position on the
To the left (◄) ↔ To the right (►)
Adjusts the image position vertically.
After selecting the item, adjust the vertical
position on the
Down (◄) ↔ Up (►)
Sets the OSD time out. (Time to wait to blank
screen without key operation.)
After selecting the item, choose the time out of
four.
5 sec. 15 sec. 30 sec.
Sets the OSD location on the screen.
After selecting the item, choose the location out
of five.
Center
Top
bar.
bar.
60 sec.
Left
Bottom
Right