Package Contents; Technical Data; General Safety Instructions For Compressed Air Tools - Parkside PDEXS 150 C2 Operating Instructions Manual

Sandpaper disc
Oil container
Teflon tape

Package contents

1 random orbital air sander
1 Teflon tape 3.28 ft (1 m)
1 oil container
1 connector nipple 1/4" (6,35 mm)
1 sanding disc Ø 6" (150 mm) (with Velcro)
5 sanding sheets (P60/P80/P100/P120/P150)
1 operating manual

Technical data

Rated speed:
Rated air pressure:
Sanding disc:
Weight (without accessories)
Noise emission values:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration emission value:
a = 8.27 m/s 2
h
Uncertainty K = 0.82 m/s
The vibration level specified in these instructions
has been measured in accordance with the stan-
dardised measuring procedure and can be used
to make equipment comparisons. The specified
vibration emission value can also be used to make
an initial exposure estimate.
PDEXS 150 C2
max. 10000 rpm
max. 90 psi
(6.3 bar)
Ø 6" (150 mm)
approx. 3.7 lb
(1.65 kg)
L = 90.4 dB (A)
pA
K = 3 dB
pA
L = 101.4 dB (A)
WA
K = 3 dB
WA
2
► The vibration level varies in accordance with the
use of the power tool and may be higher than
the value specified in these instructions in some
cases. Regular use of the electric tool in such a
way may cause the user to underestimate the
vibration. Try to keep the vibration loads as low
as possible. Measures to reduce the vibration
load are, e.g. wearing gloves and limiting the
working time. All states of operation must be
taken into account (e.g. times when the power
tool is switched off and times where the power
tool is switched on but running without load).
WARNING!
General safety
instructions for
compressed air tools
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacing accessories on
the sander or working in the vicinity of the ma-
chine. Failure to do this can result in serious
bodily injury.
■ The sanding machine for sanding sheets or the
polisher should only be adjusted, set or used by
adequately qualified and trained operators.
■ This sanding machine for sanding sheets or the
polisher may not be modified. Modifications can
reduce the effectiveness of the safety measures
and increase the risks for the operator.
■ The safety instructions should not be lost – give
them to the operator.
■ Never use damaged sanding machines for
sanding sheets or polishers.
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual. The
user must contact the manufacturer to obtain
replacement labels if necessary.
│
US - EN 3 ■