Test Run - Grizzly G0619 Owner's Manual

Deluxe small mill/drill. for models manufactured since 07/18
Hide thumbs Also See for G0619:
Table of Contents

Advertisement

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
The test run consists of verifying the following:
1) the motor powers up and runs correctly, 2) the
E-Stop button safety feature works correctly.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
-16-
To test run machine:
1.
Clear all setup tools away from machine.
2.
Press EMERGENCY STOP button in.
3.
Connect machine to power by inserting power
cord plug into a matching receptacle.
4.
Twist EMERGENCY STOP button clockwise
until it springs out (see Figure 9). This resets
the switch so the machine can start.
Figure 9. Resetting the switch.
5.
Press START button to turn machine ON.
Verify motor starts up and runs smoothly
without any unusual problems or noises.
6.
Press EMERGENCY STOP button to turn
machine OFF.
7.
WITHOUT resetting EMERGENCY STOP
button, try to start machine by pressing the
START button. The machine should not start.
— If the machine does not start, the safety
feature of the EMERGENCY STOP button
is working correctly. Congratulations! The
Test Run is complete.
— If the machine does start, immediately turn
it OFF and disconnect power. The safety
feature of the EMERGENCY STOP but-
ton is NOT working properly and must be
replaced before further using the machine.
Model G0619 (Mfd. Since 7/18)

Advertisement

Table of Contents
loading

Table of Contents