Bench Mounting; Foot Mounting - Grizzly G0619 Owner's Manual

Bench Mounting

Number of Mounting Holes ............................ 4
Diameter of Mounting Hardware Needed ..
The base of this machine has mounting holes
that allow it to be fastened to a workbench or
other mounting surface to prevent it from moving
during operation and causing accidental injury or
damage.
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Machine Base
Workbench
Figure 6. "Through Mount" setup.
Another option is a "direct mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Machine Base
Workbench
Figure 7. "Direct Mount" setup.
Model G0619 (Mfd. Since 7/18)
⁄ "
1
2
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Lag Screw
Flat Washer

Foot Mounting

Items Needed:
Foot with Hex Nut M12-1.75 ............................... 4
Four leveling feet have been included with your
mill/drill. However, for greater safety and bet-
ter performance, we recommend bolting your
machine to a sturdy workbench.
To adjust the feet on the mill/drill:
1. Place your precision level on the mill/drill
table.
2. Loosen the hex nut(s), as shown in Figure
8, and turn the feet until the mill/drill is level
side-to-side and front-to-back.
Hex Nut
Figure 8. Leveling the mill/drill.
3.
Retighten the hex nuts.
Qty
-15-