Table of Contents
Advertisement
Operation Overview
The purpose of this overview is to provide the nov-
ice machine operator with a basic understanding
of how the machine is used during operation, so
the machine controls/components discussed later
in this manual are easier to understand.
Due to the generic nature of this overview, it is
not intended to be an instructional guide. To learn
more about specific operations, read this entire
manual, seek additional training from experienced
machine operators, and do additional research
outside of this manual by reading "how-to" books,
trade magazines, or websites.
To reduce risk of eye or face injury from
flying chips, always wear approved safety
glasses and a face shield when operating
hips, always wear safety glasses when
this machine.
If you are not experienced with this type
of machine, WE STRONGLY RECOMMEND
that you seek additional training outside of
this manual. Read books/magazines or get
formal training before beginning any proj-
ects. Regardless of the content in this sec-
tion, Grizzly Industrial will not be held liable
for accidents caused by lack of training.
-18-
SECTION 4: OPERATIONS
To reduce your risk of
serious injury, read this
entire
manual
using machine.
To complete a typical operation, the operator
does the following:
1.
Examines workpiece to make sure it is suit-
able for milling/drilling.
2.
Securely clamps workpiece to table.
3.
With machine disconnected from power,
installs correct tooling.
4.
Adjusts headstock height above table.
5.
Puts on personal protective equipment.
6.
Connects machine to power and turns main
power switch ON.
7.
Presses FORWARD or REVERSE button to
suit cutting operation/tooling.
8.
Sets correct spindle speed for operation, then
presses START button to being operation.
BEFORE
9.
Uses table, headstock, or downfeed controls
to perform operation.
10. Pushes STOP button when operation is
complete.
11. Waits for spindle to completely stop before
removing workpiece or changing spindle
direction.
12. Disconnects mill/drill from power before
changing tooling.
Model G0619 (Mfd. Since 7/18)
Advertisement
Table of Contents
