Table of Contents
Advertisement
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Box 1 (Figures 3–4)
A. Assembled Mill/Drill .................................... 1
B. Drill Chuck and JT6 x R8 Arbor ................. 1
C. Oil Bottle ..................................................... 1
D. T-Nuts ......................................................... 2
E. Chuck Key .................................................. 1
F.
End Wrenches 8/10, 12/14, 17/19mm .... 1 ea
G. Spindle Spanner Wrench ........................... 1
H. Hex Wrench Set 3, 4, 5, & 6mm ........... 1 ea
I.
Drawbar Hex Wrench ................................. 1
-12-
Figure 3. G0619 out of the crate.
C
Qty
H
A
B
E
D
G
I
Figure 4. Inventory.
Model G0619 (Mfd. Since 7/18)
F
Advertisement
Table of Contents
