Table of Contents
Advertisement
POWER ON/OFF
After verifying that the terminal is properly installed, you are ready to proceed.
I.
Turn on the terminal by pushing the top half of the ON/OFF switch.
2.
Listen for an immediate beep. This indicates the power is on.
3.
Watch for the cursor to display in the upper left-hand corner of the screen.
If the CRT were warm, you would first see the screen flash several display
patterns as the power-on self test is run.
4.
Adjust the screen brightness with the thumbwheel intensity control on the
front lower right-hand corner of the video module. Turn it downward for
high contrast and upward for dim.
5.
Swivel the video module left or right and tilt it up or down, until you find
your personal comfort level.
The recommended height for the center of the screen is 10 to 20 degrees
below eye level. The keyboard should be at or below elbow height.
6.
To shut off the terminal, just push the bottom half of the ON/OFF switch.
Power On/Off 3
Advertisement
Table of Contents
