SRAM eTap AXS Service Manual page 28

Insert the lever into the hood assembly. Insert a 2.5 mm hex wrench
4
into the reach adjust bolt hole in the lever and align the wrench with
the pull rod. Push the lever into the hood assembly, and rotate the bolt
counter-clockwise to tighten the bolt to hand tight.
The reach adjust pull rod is reverse-threaded.
Install the pivot pin nut and the pivot pin bolt into the hood. Hold the
5
nut in place, then tighten the pivot pin bolt.
Adjust the reach to your desired setting.
6
Rotate the reach adjust screw clockwise to move the lever toward
the handlebar, or counter-clockwise to move the lever away from the
handlebar.
2.5 mm
2.5 mm 1.2 N·m (11 in-lbs)
2.5 mm
Electronic Subassembly Installation
2.5 mm
2.5 mm
28