SRAM eTap AXS Service Manual page 21

Apply grease to the hose barb threads.
5
Thread the hose barb into the hose until it is flush with the end of the
6
hose.
Install the compression nut onto the hose.
Do not overtighten the hose barb. Overtightening may cause damage
to the hose liner.
Thread a new compression fitting over the hose barb, counter-
7
clockwise, until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.
You must install a new hose barb and compression fitting before
reconnecting the brake lever to the hose.
Apply a thin layer of grease to the compression fitting and compression
8
nut.
NOTI CE
NOTI CE
DOT grease
T8
DOT compatible grease
21
Hose Installation