SRAM eTap AXS Service Manual page 16

Remove the o-rings from the banjo bolt.
3
Install the new o-rings and apply a thin layer of grease.
Tighten the banjo bolt with the banjo boot at the desired angle.
4
Insert the Monoblock bleed block into the caliper, then install the pad
5
retention bolt.
You must bleed your brakes before reinstalling the brake pads.
Installing the brake pads prior to bleeding the brakes could
contaminate the brake pads and could lead to a brake failure.
Spray isopropyl alcohol on the caliper and clean it with a shop towel.
6
Visually check your work. If any of the o-rings protrude from the banjo fitting or banjo bolt, remove and replace the o-ring, then repeat the
installation process.
Servicing your brakes removes all of the brake fluid from the system. You must bleed your brakes after you service the brake caliper. Consult the
eTap AXS HRD Hose Shortening and Bleed Manual at www.sram.com/service.
⚠ CAUTIO N
T25
Monoblock bleed block
⚠ CAUTION
DOT grease
5 N·m (44 in-lb)
2.5 mm
20 mm or 15 mm Thru Axle
Caliper Piston Installation
16