Replacing Lamp Holders And End Caps; Replacing Electronic Ballast - Hussmann Elite Series Installation & Operation Manual

6-4 s
eRvICe
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
REPLACING FLUORESCENT LAMP
HOLDERS AND END CAPS
The Hussmann Impact lamp holder is
designed to snap into the sheet metal of the
case . The lamp holder has a locking 'nub'
which fits inside the groove of specially
designed end caps .
Hussmann
Hussmann
Lamp Holder
Impact
Lamp Holder
Hussmann
Hussmann
Impact
End Cap
End Cap
IMPORTANT!
Always replace lamp holders and end caps
with Hussmann lamp holders and end caps .
Use of non-Hussmann parts may result in
poor electrical contact and short lamp life .
P/N 0453549_M

REPLACING ELECTRONIC BALLAST

Lamp Ballast
The lamp ballast are located in the raceway,
behind the back lower panel at the left-hand
end of the merchandiser (facing rear of case) .
NOTE: The lamp switch is located in this
panel .
To gain access:
1 . Disconnect electrical power .
2 . Remove the left lower rear panel .
3 . Service or replace ballast as required .
4 . Reconnect the electrical power .
Nub Nub
Groove
Groove
U.S. & Canada 1-800-922-1919 • Mexico 1-800-890-2900 • WWW.HUSSMANN.COM
Reassemble items as they were originally
installed .
Ballast Located
Behind This Panel
Light Switch
Remove Screws Holding Panel in Place