Step 4: Inserting The Batteries Into The Handset - Siemens pocket 2011 Tango Operating Instructions Manual

18.7.99
Stepwise startup
Phone cord
Power cord

Step 4: Inserting the batteries into the handset

Batt. compartment cover
Batt. comp. and batteries
2
Kap02.fm5
Insert the RJ-11 plug on your phone cord into the base sta-
tion. The jack on the bottom of the base station is marked
with the
Insert the phone plug on your phone cord into your phone
socket.
Insert the RJ-11 plug on your power cord into the base
station. The jack on the bottom of the base station is
marked with the
Insert the power cord plug-power supply into a 220/230V
socket (C39280-Z4-C59) or a 110/120V socket (C39280-
Z4-C69).
For safety reasons, the phone must only be op-
erated with the supplied Siemens
C39280-Z4-C59 adaptor for 220/230V voltage or
C39280-Z4-C69 adaptor for 110/120V.
The handset is powered by two batteries.
Hold the handset with the keypad side facing down.
Slot the batteries into the battery compartment.
Make sure that the +/– battery poles are aligned
correctly. The +/– marks on the plate must be
aligned with the +/– marks on the batteries.
The handset will not work if the batteries are in-
correctly inserted and it may be damaged.
Slide the cover of the battery compartment from above
into the grooves in the handset and close the compart-
ment.
Gigaset 2011 Tango: A30852-X1106-B307-2-7619
symbol.
symbol.