Table of Contents
Advertisement
Turning the System On/Off
This section describes how to turn on and off the Compact
Processor.
Note
Set the CONF/DOC/TV selector on the Remote Commander to
"CONF" when operating the Compact Processor.
Turning On
The following describes how to turn on the Compact Processor.
1
2
3
20
Chapter 1 Preparation
Make sure the TV monitor is on standby.
For details on how to set the TV monitor into a standby
state, refer to the operating instructions supplied with the
TV monitor.
Turn on the power of any other equipment to be used
during the meeting.
Set the POWER switch on the rear of the Compact
Processor to on.
Soon, the Compact Processor and the TV monitor are
turned on.
The POWER lamps (green) on the camera and the
Compact Processor light up, and the self-diagnostic starts.
The picture shot by the local camera appears on the
monitor screen after the self-diagnostic is completed.
Rear
MIC
AUDIO
VIDEO
(PLUG IN POWER)
IN
IN
AUX
1
2
AUX1
DC12V
T.120
POWER
OUT
OUT
AUX
2
MONITOR
POWER switch
Front
ISDN A
IR OUT
POWER lamps
Advertisement
Table of Contents
