Table of Contents
Advertisement
Nozzle Assembly
g280635
1.
Nozzle
2.
Nozzle clamp
3.
Nozzle pulley
4.
Nozzle motor bracket assembly
Removing the Nozzle Assembly
Installing the Nozzle Assembly
Blower Assembly: Service and Repairs
5.
Cap screw (2 each)
6.
Flange nut (10 each)
7.
Cap screw (6 each)
8.
Cap screw (2 each)
Note: For nozzle motor service information; refer to
Refer to
Figure 45
for this procedure.
1. Park the machine on a level surface, shut off the engine, and remove the key
from the key switch. Block the wheels with chocks to prevent the machine
from moving.
2. To prevent unexpected machine operation, disconnect the negative battery
cable from the battery terminal; refer to
Position the disconnected negative cable away from the negative battery
terminal.
3. Loosen the nozzle clamp fasteners and remove the nozzle clamp (item 2)
and nozzle.
4. Loosen the 2 flange-head screws and 2 flange nuts that secure the nozzle
motor bracket to the rear fan bracket, then remove the V-belt and motor
bracket assembly from the machine. Disconnect the nozzle motor from the
machine wire harness if necessary.
5. Remove the nozzle guides, pulley bearings, and nozzle pulley from the outer
housing.
6. Disassemble the nozzle motor bracket assembly if necessary.
Refer to
Figure 45
for this procedure.
1. Assemble the nozzle motor bracket assembly if necessary.
Figure 45
10.
11.
12.
Servicing the Battery (page
Page 6–16
9.
Flat washer (4 each)
Ball bearing (2 each)
Spacer (8 each)
Nozzle guide (4 each)
Nozzle Motor (page
Pro Force® Debris Blower
18237SL Rev A
5–30).
5–37).
Hide quick links:
Advertisement
Chapters
Table of Contents
