Integration Via Onboard Profinet Io - Siemens SIMATIC MV540 H Operating Instructions Manual

Process interfacing via an automation system (PLC, PC)

9.1 Integration via onboard PROFINET IO

Ident systems and MV
interface
SIMATIC MV500
(without CM)
PROFINET IO
TCP/IP
RS232
Not recommended for designing new configurations.
1)
Only in conjunction with the S7-1200 controller
2)
An FB based on the Ident profile is available for connection via Rockwell controllers.
3)
You have a variety of options available to integrate the optical reader into your automation
system.
Via the combination interface (DI/DQ, RS232 and CM):
● Integration via a communication module and Ident profile
● Integration via RS232
● Integration via DI/DQ
Via the Ethernet interface (PROFINET IO, TCP/IP):
● Integration using the Ident profile and FB 79 via PROFINET IO without an additional
communication module.
● Integration via TCP/IP
This section explains the various options for process connection.
9.1 Integration via onboard PROFINET IO
You can operate the optical reader via PROFINET IO using the MAC address. The reader
has two MAC addresses. The MAC address printed on the housing is the interface MAC
address. The port MAC address corresponds to the interface MAC address +1.
Note
Compatibility and device replacement of SIMATIC MV440 and SIMATIC MV540
Note that the SIMATIC MV440 and SIMATIC MV540 devices are mutually compatible and
can be exchanged in a PROFINET IO network without any problems.
You can find detailed information on the compatibility of the devices in the section
"Functional description (Page 21)".
104
Compatible program blocks in conjunction with ...
Ident profile
with S7-300/400/ with S7-300/-400
1200/1500
✓
--
--
FB 45 FB 79
with S7-300/-400
1)
--
--
--
Operating Instructions, 06/2018, C79000-G8976-C494-01
Without a dedicated
FB
✓ ✓
-- ✓
-- ✓
SIMATIC MV500