Foxconn WinFast 6150K8M Series User Manual page 51

continues. When you select the "V/H SYNC + Blank" mode the vertical and horizontal
scanning movement of screen stops when the computer enters power saving
mode. "DPMS Supported" mode is a new screen power management system,
and it needs to be supported by the monitor you're using.
vHDD Power Down
This option is used to turn off hard disk power if the hard disk is idle for a given
period of time. The setting values are Disabled and 1Min-15Min.
vHDD Down In Suspend
This option is used to define the continuous HDD idle time before the HDD
enters power saving mode. The setting values are Disabled and Enabled.
vSoft-Off by PBTN
This option is used to set the power down method. This function is only valid
for systems using an ATX power supply. When "Instant-Off" is selected, press
the power switch to immediately turn off power. W hen "Delay 4 Sec." is
selected, press and hold the power button for four seconds to turn off power.
vWOL(PME#) From Soft-Off
W hen set to Enable, the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event).
vWOR(RI#) From Soft-Off
If this item is enabled, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an in-
stalled fax/modem. This function needs to be supported by the relevant hard-
ware and software.
vUSB Resume from S1/S3
This item is used to set the system to wake up by USB equipment when it is
in S1/S3 mode.
vMAC Resume from S4/S5
This item is used to set the system to wake up by MAC equipment when it is
in S4/S5 mode.
vCase Open Warning
This option is used to enable or disable case open warning function.
vPower-On by Alarm
This option is used to enable or disable the feature of booting up the system
on a scheduled time/date.
44
Chapter 3 BIOS Description