Foxconn WinFast 6150K8M Series User Manual page 25

Chassis Intruder Connector: INTR
The connector connects to the chassis security
switch on the case. The system can detect the
chassis intrusion through the status of this
connector. If the connector has been closed
once, the system will send a message. To uti-
lize this function, set "ICase Open W arning" to
"Enabled" in the "Power Management Setup"
section of the CMOS Setup. Save and exit, then
boot the operating system once to make sure
this function takes effect.
Front Audio Connector: F_AUDIO
The audio port includes two parts – the Front
Audio and Rear Audio. Their priority is se-
quenced from high to low (Front Audio to Rear
Audio). If headphones are plugged into the front
panel of the chassis (using the Front Audio),
then the Line Out (Rear Audio) on the rear panel
will not work. If you do not want to use the Front
Audio, pin 5 and 6, pin 9 and 10 must be short,
and then the signal will be sent to the rear au-
dio port.
TV OUT Connector: TV_OUT (optional)
This connector is for TV out function. Using this
function, you can use a TV or projector as display
device. The following steps are provided refer-
ence only.
Step 1. Install TV out cable to a slot opening at the back of the system chassis (As
figure 1).
A
Note:
The triangle direction on the 3-pin connector should be aligned
to 1st pin of the TV out connector on the motherboard.
18
Chapter 2 Installation Instructions
INTRUDERJ
GND
MIC_IN
MIC_PWR
AUD_OUT_R
NC
AUD_OUT_L
Figure 1
2
1
INTR
1 2
MIC_GND
+5VA
AUD_RET_R
EMPTY
AUD_RET_L
9 10
F_AUDIO
1
S_VIDIO_C
S_VIDIO_Y
GND
TV _OUT
B