Foxconn WinFast 6150K8M Series User Manual page 23

Power LED Connector (PLED)
Attach the connector to the Power LED on the front panel of the case. The Power
LED indicates the power supply status. W hen the system is in S0 status, the
green LED is on. W hen the system is in S1 status, the green LED is blink. When
the system is in S3, the yellow LED is blink. When the system is in S4, S5 status,
the LED is off.
Power Switch Connector (PW RBTN#)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
USB Connectors: F_USB 1, F_USB 2
Besides four USB ports on the rear panel, the series of motherboards also
have two 10-pin connectors on board which may connect to the front panel USB
cable to provide additional four USB ports.
NC
GND
D5+
D5-
VCC
F_USB1
IrDA Connector: IR
The IrDA infrared transmission allows your com-
puter to send and receive data via an infrared ray.
The relevant parameters for the BIOS Integrated
Peripherals should be set prior to using this
function.
Fan Connectors: CPU_FAN, SYS FAN
There are two fan connectors on this motherboard.
1
CPU_FAN
16
Chapter 2 Installation Instructions
10 9
Empty
GND
D4+
D4-
VCC
2 1
SENSE
+12V
GND
10 9
Empty
NC
GND GND
D7+
D6+
D7-
D6-
VCC VCC
2 1
F_USB2
1
IR
1
GND
+12V
SENSE
SYS FAN
IRTX
GND
IRRX
Empty
+5V