Supplied Accessories; Quick Reference; Attaching The Stand - Sharp AQUOS LC-42D64U Operation Manual

Supplied accessories
Make sure the following accessories are provided with the product.
f
Remote control unit "AAA" size battery AC cord
(xl) (x2) (xl)
Page 8 Page 8 Page 7
Cable clamp (x 1) Stand unit Operatbn manual
Cable tie (x 1) (x 1) (x 1)
Page 7 Page 6
,J
,, Always use the AC cord supp[bd with the TV.
,, AC cord enclosed in this product is for 110-125V. In using it on the 125 240V AC, phase consult to the following.
SHARP ELECTRONICS CORPORATION, LATIN AMERICA GROUP
6100 Blue Lagoon Drive, Suite 150, Miami, Florida 33126, U.S.A.
QUICK REFERENCE
• Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it
from being damaged.
• Attach the stand in the correct direction.
• Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.
Confirm that there are 8 screws (4 short
screws and 4 long screws) supplied with the
stand unit.
Attach the supporting post for the stand unit
onto the base using the box for the stand unit
as shown below.
,, The supporting post attaches to the base at
an off centered location on the base. Be sure
to attach the supporting post in the direction
indicated bebw and attach the stand to the TV
with the wider side of the base facing forward.
Hex key
screws _
(_ Insert the stand into the openings on the
bottom of the TV.
(_) Insert and tighten the 4 short screws into
the 4 holes on the rear of the TV.
,, To detach tile stand, perform the steps in reverse order.
(@)-6