Table of Contents
Advertisement
Messages and Signals
Display messages
CHECK PAPER SIZE
COVER OPEN
DOCUMENT JAM
FAX RX IN MEMORY
FILM END
FUNCTION MODE
LINE ERROR
LINE IS IN USE
MEMORY IS FULL
MEMORY PRINTING
ON HOOK DIAL
OUT OF PAPER
OVER HEAT
PAPER JAMMED
Chapter 12
The paper size setting is incorrect. Change the
paper size setting as described in "Loading the
Paper" in Chapter 1.
The printing compartment cover is open. Close it.
The original document is jammed. See the
following section, "Clearing Paper Jams".
A fax has been received in memory because the
imaging film needs replacement, you have run
out of printing paper, or the paper is jammed.
The fax will print out automatically when the
problem is fixed.
The imaging film may need replacement. Check
the film and replace it if necessary.
FUNCTION
The
key has been pressed.
Transmission or reception was not successful.
STOP
Press
to clear the message, and then try
again.
An extension phone connected to the fax is being
used. Do not lift the fax's handset or attempt
transmission at this time, as this will interrupt the
conversation on the extension phone.
The memory is full. See "Memory" in Chapter 8.
The fax is preparing to or printing out a document
from memory.
The
SPEAKER
key has been pressed and the
fax is waiting for you to dial.
You are out of printing paper.
The print head has overheated. Operation can be
continued once it cools.
The printing paper is jammed. See the following
section, "Clearing Paper Jams".
Troubleshooting
89
Advertisement
Table of Contents
