Table of Contents
Advertisement
Explanation of headings
SENDER/
The fax number of the other machine involved in the transaction. If this
RECEIVER
machine does not have an ID function, the communication mode will appear
(for example, "G3").
PAGES
Number of pages transmitted or received.
NOTE
OK
P.FAIL
JAM
NO PAPER
CANCEL
pressed, no document was in the feeder, or the other machine requested
transmission using a function which your fax does not have.
COM.E-0
Explanations of the error numbers are given in the following tables, however,
these are primarily for use by service engineers. In general, you will want to
simply try the transaction again. If necessary, check with the other party to
make sure their machine is functioning properly.
Transmission errors
Able to recognize handshake signal, but it has errors.
E-0
Cannot recognize the handshake signal from the receiver side.
E-1
Line disconnected during transmission.
E-2
Line disconnected after modem speed fall-back.
E-3
Line disconnected during multi-page transmission.
E-4
E-6
Cannot recognize the handshake signal for next page at receiver side.
No response from receiver side or "disconnect signal" is received at transmitter
E-7
side.
Error was not corrected after the predetermined number of retries because of an
E-8
error in a part of a page.
Error occurred after or while reception by the remote (receiving) machine was
E-11
revealed to be impossible.
Error occurred just after fall-back.
E-12
Error occurred after a response to a retransmission end command was received.
E-13
- Transmission/reception was normal.
- A power failure occurred.
- A problem with the fax paper or document occurred.
- You ran out of fax paper during reception.
- Transmission was cancelled because the
COM.E-14
to
Chapter 10
Printing Reports and Lists
- A telephone line error prevented the transaction.
STOP
key was
79
Advertisement
Table of Contents
