Table of Contents
Advertisement
Software-Based
Configuration and
Control
This section of the guide is divided into the following topics:
•
•
•
•
Configuration and Control: an Overview
An MLC must be configured before use in order to recognize and accept commands
and pass them on to the controlled devices. It can be configured and controlled via a host
computer attached to the same network as the controller. See
LEDs
the network.
•
•
Configuration and Control: an Overview
Basic Setup Steps: a Guide to this Section and Other Resources
Downloading the Software and Getting Started
Troubleshooting
on page 20 for details about the LAN port and cabling to connect the controller to
Configure the controller by using the Global Configurator software (GC Professional or
GC Plus). See the Extron website for full system hardware and software requirements.
The default web pages embedded within the controller provide a means to view general
hardware information, network settings, and, if configured, project information. The
embedded web pages can also be used to update the firmware. You cannot configure
the controller via the embedded web pages.
NOTE: See the diagram within
default login credentials for the MLC Plus internal web pages.
MLC Plus 84 Series • Software-based Configuration and Control
LAN and PoE port and
LAN and PoE port and LEDs
MLC Plus 84 Series • Operation
on page 20 for the
38
38
Advertisement
Table of Contents
