Normal Copying; Copying From The Document Glass; Document Glass - Sharp AR-M236 Copier Manual

NORMAL COPYING

COPYING FROM THE DOCUMENT GLASS

If "AUDITING MODE" (p.55) has been enabled, enter your 5-digit account number.
Note
1
Open the document cover/RSPF and
place the original face down on the

document glass.

[How to place the original]
Align the corner or the original with the tip of the arrow
( ) at the left rear corner of the glass as shown in the
illustration.
Original scale
B5 B4
A4 A3
2
Close the document cover/RSPF.
If the original size is not automatically
Note
detected, manually set the original size. (p.47)
3
Make sure that the same size of paper
as the original is automatically
selected.
ORIGINAL A4
AUTO
EXPOSURE
AUTO
A4
PAPER SELE
A4
A3
100%
COPY RATI
Even if the message above is displayed, copying can
be performed using the selected paper tray.
22
Original scale
B5
R
A4
R
The original size appears
in the touch panel.
The selected tray is
highlighted. If the tray
contains a different size of
paper than the original,
A4
"LOAD xxxx PAPER." will
appear.
• To load paper, see "LOADING PAPER"
Note
(p.15). If you change the paper size in the
tray, you will also need to change the tray's
paper size and paper type settings. (p.19)
• The paper types for the auto paper selection
function can be selected, or the function
disabled, in the key operator programs. (See
the "Key operator's guide".)
Manually selecting the paper size (paper tray)
If auto paper selection is disabled in the key operator
programs, or if you wish to use a different size of paper than
the original, touch the [PAPER SELECT] key and select the
paper tray with the desired paper size. (The selected paper
will be highlighted and the paper selecting screen will close.)
To close the screen without selecting a paper size, touch the
[PAPER SELECT] key again.
READY TO COPY.
PLAIN
1.A4
2.A3 RECYCLED
4
Select the number of copies and any
other desired copy settings, and then
press the [START] key (
ACC.#-C
• The number in the copy quantity display will decrease
by 1 each time a copy is made.
• If you are only making a single copy, the copy can be
made with the copy number display showing "0".
• To clear a mistake, press the [CLEAR] key (
• Press the [CLEAR] key (
Note
copying in the middle of a run.
• To repeat the same copy sequence for a
different original, simply replace the original
and press the [START] key (
• If copying stops because the tray has run
out of paper, you can resume copying by
touching the [PAPER SELECT] key and
selecting the bypass tray or a paper tray that
has the same size and type of paper loaded
in the same orientation.
0
AUTO
A3
EXPOSURE
PLAIN
PAPER SELECT
EXTRA IMAGE 100%
ADJUST
COPY RATIO
).
).
) to stop
).