Copy Functions; Normal Copying - Sharp MX-M200D Operation Manual

4

COPY FUNCTIONS

This chapter explains the basic procedures for making copies, including selection of the copy ratio and other copy
settings.

NORMAL COPYING

This section explains how to make a regular copy.
If "Auditing mode" has been enabled (page 23), enter your 5-digit account number.
Copying from the document glass
1
Open the RSPF and place the original
face down on the document glass.
An original up to 11" x 17" (A3) can be
Note
placed on the document glass.
2
Close the RSPF.
If the original is a non-standard size or the
Note
size was not detected correctly, see
"SELECTING THE ORIGINAL SIZE" (page
50).
Align the upper left-hand corner
of the original with the tip of the
mark.
The original size is
automatically detected.
3
Make sure that the desired paper tray
is selected.
Ready to copy.
8 x11 1
2
AUTO
100%
8 x11 1
AUTO
2
To load paper, see "LOADING PAPER" (page 18).
• If the auto paper select function has been
Note
disabled in the system settings (see the
"System settings guide"), use the
[PAPER] key to select the desired paper
size.
• If you wish to use a size of paper different
from the size automatically selected by
the machine, use the [PAPER] key to
select the desired paper size.
• Paper in a different orientation from the
original can be selected if the auto paper
select or auto image function has been
selected. In this case, the image of the
original will be rotated.
• To make a copy of a small original such as
a card, follow the procedure in "USING
THE BYPASS TRAY TO COPY A
SPECIAL SIZE ORIGINAL" (page 51).
• To use the bypass tray, select it manually.
4
Set the number of copies.
If you are making two or more copies each
Note
of multiple original pages, you can select the
sort function to collate the copies into sets.
(Page 64)
45