Copy Functions; Normal Copying - Sharp AL-1035-WH Operation Manual

Chapter 2
2

COPY FUNCTIONS

This chapter explains how to use the copy functions.

NORMAL COPYING

This section explains how to make a regular copy.
1
Open the document cover and place
the original.
[How to place the original]
The corners of the original shall be aligned with the tip of
the arrow mark (
A4 11x8
An original up to A4 can be placed on the
Note
document glass.
2
Close the document cover.
Place the original face
down on the document
glass.
) on the scale mark of document glass.
1/2
A5
8 x5
1/2 1/2
A6
ID
Mark
Document glass scale
Be sure to close the
document cover after
placing the original. If left
open, the areas outside
the original will be copied
black, causing excessive
use of toner.
3
Set the number of copies with the
[COPY COUNT] key (
Up to 9 copies can be set.
A Single copy can be made even if "0" appears
for the number of copies.
If you set the wrong number of copies, press
Note
the [CLEAR] key (
correct number.
4
Press the [COPY START] key (
copy start.
• Remove the paper on the output tray
Note
whenever 10 sheets have been delivered.
• About 1 minutes after copying ends, the
copy settings will restore to the initial
settings.
• Press the [CLEAR] key (
copying in the middle of a run.
Copying books or originals with folds or creases
Press down the document cover, while copies as
shown. If the document cover is not completely closed,
shadows may appear on the copy or it may be fuzzy.
Flatten originals with folds or creases well before
printing.
15
).
) and then enter the
) to
The copy is delivered to
the paper output tray.
) to stop