Tightening Belt; Disabling & Locking Switch - Grizzly G0855 Owner's Manual

Tightening Belt

The final step in the setup process must be done
after approximately 16 hours of operation. During
this first 16 hours, the belt will stretch and seat
into the pulley groove. After this time, you must
re-tension the belt to avoid slippage and burn out.
Refer to Page 52 when you are ready to perform
this important adjustment.
Note: Pulleys and belt can get hot. This is a nor-
mal condition. Allow them to cool before making
adjustments.
A small amount of black belt dust at the bottom
of the belt housing is normal during the life of the
machine and does not indicate a problem with the
machine or belt.
-26-
Disabling & Locking
Switch
The switch can be disabled and locked by insert-
ing a padlock through the ON/START button, as
shown. Locking the switch in this manner can
prevent unauthorized operation of the machine,
which is especially important if the machine is not
stored inside an access-restricted building.
IMPORTANT: Locking the switch with a padlock
only restricts its function. It is not a substitute
for disconnecting power from the machine when
adjusting or servicing.
Shaft
ON / START
Button
OFF / STOP
Paddle
Figure 25. Switch disabled by a padlock.
Children or untrained people can be
seriously injured by this machine. This
risk increases with unsupervised operation.
To help prevent unsupervised operation,
disable and lock the switch before leaving
machine unattended! Place key in a well-
hidden or secure location.
NOTICE
The padlock shaft diameter is important to
the disabling function of the switch. Use
padlocks with a maximum shaft diameter
of 4mm. With any padlock used to lock the
switch, test the switch after installation to
ensure that it is properly disabled.
Model G0855/G0856 (Mfd. Since 02/19)
Padlock