Disassembling Upper and Lower Cabinet
Sections
The Vertical Stack unit cabinet ships completely assembled. If
required, it may be disassembled into two (2) sections (upper-
fan/discharge cabinet) and (lower chassis/return air cabinet) to
make it easier to handle. To disassemble, do the following.
1 . Remove risers (if received attached).
2 Remove the three (bottom row) screws on the back of the
unit as shown in
Figure
Note: Retain all screws for later use to reassemble unit in
reverse order as described in steps 1-6. Number of
screws will vary depending on unit size.
3 . Carefully lay the unit down on its back and remove the
remaining eight (8) screws on the left and right side of the
cabinet
(Figure
3).
4 . Remove the ten (10) screws and lift off the front panel/filter
rack to gain access to the cabinet interior
5 . Locate and remove the six (6) screws located inside the
cabinet joining the upper and lower cabinet sections
(Figure
5).
Note: Pull the insulaton away from the walls of the cabinet
interior to get access to the screws.
6 . Separate the lower return air cabinet section from the upper
blower/discharge cabinet section
Figure 2: Remove three (3) screws (bottom row) on the
back of the unit.
IM 986-11 • Vertical Stack WSHP
2.
(Figure
4).
(Figure
6).
Back of Unit
Three screws (bottom row)
Figure 3: Remove remaining eight (8) screws on the left
and right sides of the cabinet
Figure 4: Remove the ten (10) screws from the front panel/
filter rack.
Figure 5: Remove the six (6) screws located on the interior
of the unit.
Return air cabinet
section interior
Figure 6: Separate the lower cabinet section from the
upper cabinet.
8
P
i
rior to
nstalling
Four (4) screws located
on left side of cabinet
www.DaikinApplied.com