Card Reader Board - HP ZBook 15v G5 Maintenance And Service Manual

Card reader board

Table 5-7 Card reader board description and number
Description
Card reader board
Card reader board cable
Before removing the card reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
6. Remove the hard drive (see
To remove the card reader board:
1. Disconnect the cable from the ZIF connector on the card reader board (1).
2. Remove the tape from the board (2).
3. Remove the two Phillips M2.0×2.0 screws (3) that secure the board to the computer.
4. Lift the rear of the board up, and then pull it away from the side of the computer to remove it (4).
Reverse this procedure to install the card reader board.
50 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
Bottom cover on page
Battery on page 40).
Hard drive on page 48).
38).
Spare part number
L25225-001
L20330-001