Removing And Installing Hardware Components; Removing The Device Fan - Siemens SIMATIC IPC347E Operating Instructions Manual

6.4

Removing and installing hardware components

6.4.1

Removing the device fan

Requirement
● The device is disconnected from the mains.
● The front panel cover is open
● PH2 screwdriver
● A fan with the same type
Procedure - Removing the fan
1. Unlock the front cover with the key.
2. Pull the handle in the direction of the arrow
to open the left-front door.
3. Unscrew the marked screws.
4. Pull the marked screw to open the fan
bracket.
5. Remove the highlighted screws.
6. Remove the fan in the direction of the
arrow.
7. Pull the fan plug from the connector.
Procedure - Installing the fan
To install the fan, follow the steps for removing it in reverse order. During installation, make
sure that the arrow on the fan points away from the fan bracket.
SIMATIC IPC347E
Operating Instructions, 09/2018, A5E41134132-AE
6.4 Removing and installing hardware components
Device maintenance
53