Remote Control Setup - Kohler K-5401-PA Homeowner's Manual

Docking Station
Remote Control – Setup
NOTE: The remote control must be charged to operate. The "Stop" icon will blink when the remote needs
to be charged.
Charging the Remote
Verify that the docking station has batteries installed. Refer to the "Replacing the Batteries" section.
Place the remote control on docking station.
The remote is fully charged when the "Stop" icon stops blinking.
Pairing to the Toilet
IMPORTANT! The remote control cannot be paired to the toilet while the toilet is occupied.
NOTE: The icons on the bottom row of the remote control will flash when the remote is not paired or is
out of range of the toilet.
Press the power button to turn on the remote control.
Move the remote control within close proximity to the toilet. The bottom row of icons should be
flashing.
Press and hold the "lighting" icon on the side control panel. Release the icon after the night light
blinks three times.
Press and hold the "Dryer" icon on the remote control.
While holding the "Dryer" icon on the remote control, press and hold the "rear" and "front" icons
simultaneously on the side control.
When pairing is successful, the bottom icons will stop flashing.
Kohler Co.
Power Button
5
Side Control Panel
1325704-5-A