Table of Contents
Advertisement
Programming
14.6.3 Setting the Speed (Speed) parameter
Various settings can be made for the speed. The possibilities are explained
in more detail in the table.
Menu item
Max Speed
Min. Speed
Pos. Speed
Soft Speed
N Stitches
Acceleration Slope of the acceleration ramp
Deceleration Slope of the deceleration ramp
14.6.4 Setting the Stop positions (Stop Positions) parameter
Various settings can be made for the stop positions. The possibilities are
explained in more detail in the table.
Menu item
StopBottom°
Threading°
StopTop°
StopIdle°
Service Instructions 667 PREMIUM - 03.0 - 01/2018
Setting options
Maximum permissible speed; it can no longer be exceeded on the
operator level.
(Value range 0500 - 3800 [rpm], depending on the subclass)
Minimum speed at which an individual stitch is made; a lower speed is
no longer possible at operator level.
(Value range 050 – 400 [rpm])
Position speed; the last stitch is made slower during stopping of the
sewing procedure.
(Value range 010 – 700 [rpm])
Speed for the soft start.
(Value range 0010 – 1000 [rpm])
Number of stitches to be made during a soft start.
(Value range 00 – 10)
(Value range 10 - 40 [rpm/ms])
(Value range 10 - 40 [rpm/ms])
Setting options
Holding position of the needle in the material.
Value range (000 – 359)
Position for the proper function of the threader, e.g. with thread lever
at top dead center.
Value range (000 – 359)
Holding position of the needle outside of the material.
Value range (000 – 359)
Stop position after thread cutting (reversal position).
Value range (000 – 359)
79
Advertisement
Table of Contents
