Safety Information; Electromagnetic Compatibility Guidelines - National Instruments myRIO-1950 User Manual

Safety Information

Caution
and in the user documentation. Misuse of the hardware can result in a hazard. You
can compromise the safety protection if the hardware is damaged in any way. If the
hardware is damaged, return it to National Instruments for repair.
Clean the hardware with a soft, nonmetallic brush. Make sure that the hardware is completely
dry and free from contaminants before returning it to service.

Electromagnetic Compatibility Guidelines

This product was tested and complies with the regulatory requirements and limits for
electromagnetic compatibility (EMC) stated in the product specifications. These requirements
and limits provide reasonable protection against harmful interference when the product is
operated in the intended operational electromagnetic environment.
This product is intended for use in commercial locations. There is no guarantee that harmful
interference will not occur in a particular installation or when the product is connected to a test
object. To minimize interference with radio and television reception and prevent unacceptable
performance degradation, install and use this product in strict accordance with the instructions
in the product documentation.
Furthermore, any modifications to the product not expressly approved by National Instruments
could void your authority to operate it under your local regulatory rules.
Caution
connected to the USB ports must be no longer than 3 m (10 ft), and the length of any
cable connected to the MXP ports must be no longer than 0.3 m (1 ft).
Caution
to a DC mains supply or to any supply requiring a connecting cable longer than 3 m
(10 ft). A DC mains supply is a local DC electricity supply network in the
infrastructure of a site or building.
2 | ni.com | NI myRIO-1950 User Guide and Specifications
Do not operate the hardware in a manner not specified in this document
To ensure the specified EMC performance, the length of any cable
To ensure the specified EMC performance, do not connect the power input