Table of Contents
Advertisement
Chapter 1
Getting Started with Your NI 653X
In Mac OS
Caution
Do not configure the NI 653X resources in conflict with non-NI devices. For
example, do not configure two devices to have the same base address.
The NI PCI/PXI-7030/6533 configuration is similar to NI PCI/PXI-653X
Note
configuration with a few exceptions. Refer to your RT Series DAQ Device User Manual
for specific configuration details.
Note
If you are using the NI AT-DIO-32HS in a non-Plug and Play system, the device
automatically configures to a switchless DAQ device so that it can work in the system.
Safety Information
NI 653X User Manual
To view and test current resource allocation, complete the following steps:
1.
Open the NI-DAQ Configuration Utility.
2.
Select the device you want to configure.
3.
Click the Configure button.
4.
Click the Test Resources button to test hardware resources.
Now that you have completed configuring your device, you can begin
setting up the device for use.
The following section contains important safety information that you must
follow when installing and using the product.
Do not operate the product in a manner not specified in this document.
Misuse of the product can result in a hazard. You can compromise the
safety protection built into the product if the product is damaged in any
way. If the product is damaged, return it to National Instruments for repair.
Do not substitute parts or modify the product except as described in this
document. Use the product only with the chassis, modules, accessories, and
cables specified in the installation instructions. You must have all covers
and filler panels installed during operation of the product.
Do not operate the product in an explosive atmosphere or where there may
be flammable gases or fumes. If you must operate the product in such an
environment, it must be in a suitably rated enclosure.
1-10
ni.com
Advertisement
Table of Contents
