Table of Contents
Advertisement
Unpacking
Caution
To avoid electrostatic damage to the DAQCard-700, never touch the exposed pins
of connectors.
Safety Information
© National Instruments Corporation
The DAQCard-700 is shipped in an antistatic package to prevent
electrostatic damage to the device.
Because the DAQCard-700 is enclosed in a fully shielded case, no
additional electrostatic precautions are necessary.
Remove the DAQCard-700 from the package and inspect the device for
loose components or any sign of damage. Notify NI if the DAQCard-700
appears damaged in any way. Do not install a damaged device into your
computer.
Store the DAQCard-700 in the antistatic envelope when not in use.
The following section contains important safety information that you must
follow when installing and using the product.
Do not operate the product in a manner not specified in this document.
Misuse of the product can result in a hazard. You can compromise the
safety protection built into the product if the product is damaged in any
way. If the product is damaged, return it to NI for repair.
Do not substitute parts or modify the product except as described in this
document. Use the product only with the chassis, modules, accessories, and
cables specified in the installation instructions. You must have all covers
and filler panels installed during operation of the product.
Do not operate the product in an explosive atmosphere or where there may
be flammable gases or fumes. Operate the product only at or below the
pollution degree stated in Appendix A, Specifications. Pollution is foreign
matter in a solid, liquid, or gaseous state that can reduce dielectric strength
or surface resistivity. The following is a description of pollution degrees:
•
Pollution degree 1 means no pollution or only dry, nonconductive
pollution occurs. The pollution has no influence.
1-5
Chapter 1
Introduction
DAQCard-700 User Manual
Advertisement
Table of Contents
