Rs232 Serial Interface - SATO M-84PRO Operation Manual

Section 6. Troubleshooting

RS232 SERIAL INTERFACE

The High Speed Serial Interface is a Plug-In Interface Module that can be installed in
the printer by the user.
GENERAL SPECIFICATIONS
Asynchronous ASCII
Data Transmission Rate
Character Format
ELECTRICAL SPECIFICATIONS
Connector DB-25S (Female)
Cable
Signal Levels
PIN ASSIGNMENTS
Page 6-4
Half-duplex communication
Ready/Busy Hardware Flow Control
Pin 20, DTR Control
Pin 4, RTS Error Condition
X-On/X-Off Software Flow Control
Bi-Directional Communication
9600, 19200, 38400, 57600 bps
1 Start Bit (fixed)
7 or 8 data bits (selectable)
Odd, Even or No Parity (selectable)
1 or 2 Stop bits (selectable)
DB-25P (Male), 50 ft. maximum length.
For cable configuration, refer to Cable
Requirements appropriate to the RS232C
protocol chosen.
High = +5V to +12V
Low = -5V to -12V
Operation Manual
SATO M-84PRO